p0300, ruh roh!

[pajeff02]

Have you pinpoint tested the MAF harness for voltage, ground and such?

[Tbocambridge]

Yes wiring is good found the problem today. Cylinder 2 and 3 put air to it for a leakdown test does not pass valve bent or stuck not sure called the place we got motor from and there sending new with air in the cylinder you can actually feel it coming out of the exhaust its crazy has 145 compression at idle or just by cranking and no start still 145 leave compression tester on it bring the rpms up and compression starts to drop thank you guys for all the help

[pajeff02]

Wow - that's very odd that it was doing that. Lifter maybe pumping up and not allowing the valve to close under rpms... or weak valve springs?

[Tbocambridge]

Not sure put bore scop in you can see a odd coloration towards the top of cylinder walls on them two cylinders

- - - Updated - - -

Color is like maybe there was water sitting there at one time

[pajeff02]

That could be... glad you found the issue and hope you fare better with the next engine.

[Tbocambridge]

We hope so out a lot of time and parts on this one thanks again