My 2011 Build Thread (pic heavy)

[JDHedman]

Thanks it is going slow right now. Will pick up again this week.

[JDHedman]

Today I picked up the Dana S60 and drive shaft from Strange.


I also got the Spindle and brakes off, the new QA1 springs with bearing kits in and replaced the belt tensioner



tomorrow the racecraft k-member goes in the Saturday I will hopefully get the rear end and drive shaft in then all thats left to do is plugs, throttle cable and some other small stuff.

[JDHedman]

last night me and a buddy pulled the k-member out and got the new one in

used some ratchet straps from the headers to the strut tower brace to hold the motor up

out with the old



in with the new



only problem we really ran into was one of the A arm bolts was seized in the bushing. had to beat it out and messed up the bolt in the process but bolts are cheap. Wish I was putting in these too