‘02 Z28, Bolt-On Mods, Before & After Dyno Numbers
I recently went through the typical “Bolt-On mods” for my ’02 Z28 m6. I was curious how much I’d really be gaining from the mods I’d be doing so I had the car dyno’d before and after the mods (same DynoJet dyno used both times). I Thought I’d post the results for those who may have the same questions I did before I started. Fuel used in both dyno runs is 93 octane (10% ethanol) from Costco, although the tank used for the “after” dyno run had TC-W3 two-stroke oil added (1oz/5gal) as described in this thread.
The “Before” configuration:
Car was 99% stock, a stock tune on the PCM & had just under 79k mi on it. Changes from stock include (not saying these have anything to do with power, just laying it all out there for the reader to use as they please):
- Subframe connectors
- New billet steel flywheel
- New Centerforce Dual Friction clutch
- New clutch master & slave cylinders
Dyno results for this stock configuration resulted in peak numbers of 299.67hp/323.36ft-lb torque. Here’s the chart:
http://img175.imageshack.us/img175/4...0629before.jpg The “After” configuration:
- SLP Air Lid
- SLP Smooth Bellow
- Free Ram Air mod
- K&N Air Filter
- ARH 1-3/4” primary Headers w/3” catted Y-pipe
- DEI Header Wrap (only wrapped primaries up to but not including the welds on the collectors)
- Magnaflow 3” Cat-Back Exhaust
- New front O2 sensors (Bosch 13111)/reused stock rear O2 sensors
- 160° Thermostat
- MSD 8.5mm wires
- New AC Delco 41-985 plugs
- Saikou Michi Stage 1 LS1 Dual Oil Catch Can
- Tuned By Frost mail order tune
- New Fuel Filter
- Prothane Poly Motor & Tranny mounts
Note: I retained the AIR system
Dyno results for the “After” configuration resulted in peak numbers of 336.95hp/347.18ft-lb torque. Here’s the chart
http://img94.imageshack.us/img94/5387/20100817after.jpg Hope this helps…