Aligning M6 Input shaft and pilot bearing
Having a major problem getting my transmission mated up again. I usually dont have this problem. Using a transmission jack, engine is tilted down(tried level but tranny hit car). Spent 6 hours wrestling it. Finally I got a 1/4 gap and started to pull it together ( I know thats bad) and it was coming together with 1 bolt but others didnt align and gap on top was larger then bottom for I figured I screwed up the bearing so I pulled it. Bearing was fine. I matched the angle of the face of the bellhousing with the face of the tranny. Problem that I see is you cant push something together thats on an angle. The input shaft tip is perfect and the alignment tool goes in and out fine. So what the heck is the trick to get it together?